No More Burying. A Total Ease In Underground Pet Fence System

Say goodbye to the hassles of burying wire! Most people believe that the wire use in underground pet fence systems needs to be buried “underground”. Though it is still recommend burying the wire so dog owners don’t practically need to deal with it over and over again, owners can be spared from doing that.

Wants an underground pet fence but is worried of installation problems, then here’s an interesting and truly helpful product especially created for any needs.

With the underground pet fence, owners can now have a containment system that will take all the worries away. Installation hassles? Dog Safety troubles? We have the solution for that! Containment will never be a problem again just because dog owners are renting the house, or don’t have any tools or no one will dig the ground for dog owners. With the wire securing staples and through above ground installation, all it takes is for the owner to lay the wire down and after a good rain the wire will sink and dog owners won’t be able to see it again. Truly a perfect hassle free solution to underground pet fencing.

 

Below are the steps to follow in above ground installation:

Step 1:

» First lay out the boundary wire in the desired shape and around the area dog owners want to contain. From the boundary wire run twisted wire to the transmitter and pug it in.
» Once dog owners have decide the system dog owners chose is correct for dog owners, "Staple" the twisted wire to the ground by hammering in a wire "Staple" every 5 - 6 feet.
» Now stop and look at the wire. Is it completely flush to the ground all the way to the start of the boundary? The wire MUST completely touch the ground. If not go and "Staple" any raised areas before proceeding to the next step.

Step 2:

» Place a "Staple" where the twisted wire and the beginning of the boundary meet (if dog owners have a splice in this area please dig a small hole about 2 inches deep and bury the splice. Then place a "Staple" in the front of and behind the splice to relieve any pressure on the splice)
» Next, walk to the first corner of the boundary and "Staple" it to the ground. Repeat this step for all corners of the boundary. (Not all yards are square if dog owners do not have corners on the boundary please select multiple anchor points for the wire)
» Now place staples as needed and make sure to staple any raised areas down until they are completely flush with the ground, for maximum safety for dog owners and the guests.